Remote Users Page - AudioCodes Mediant 800 User Manual

CHAPTER 51 SBC Configuration Wizard
➢
To configure number manipulation:
1. Configure number manipulation:
a. Under the Outbound Calls and/or Inbound Calls groups, select the required manipulation
check box:
◆
◆
b. In the 'Prefix' field, configure the prefix (digits at the beginning of the number) to which you
want to apply manipulation. If configured to "*" (asterisk), manipulation is applied to all
numbers.
c. In the 'Remove' field, configure the number of digits to be removed from the beginning of
the number. If configured to "0", no digits are removed.
d. In the 'Add' field, configure a new prefix to be added to the beginning of the number. If not
configured, no prefix is added.
The example below changes the number "+15033311432" to "03311432":
● Prefix: "+1503"
● Remove:"4"
● Add: "0"
2. To enable routing by ARM, select the 'Use ARM for call routing' check box, and then configure
the following fields:
● 'Host': IP address or FQDN of the ARM server.
● 'Username': Username for communication with ARM.
● 'Password': Password for communication with ARM.
3. Click Next; Remote Users (FEU) page appears (see

Remote Users Page

The Remote Users (FEU) wizard page configures the remote users settings.
Destination Number Manipulation: Manipulates the destination number.
Source Number Manipulation: Manipulates the source number.
Mediant 800 Gateway & E-SBC | User's Manual
Remote Users
- 976 -
Page).