Ldap Parameters - AudioCodes Mediant 800 User Manual

CHAPTER 72 Configuration Parameters Reference
Parameter
'Password Local Cache
Mode'
configure system >
radius settings >
local-cache-mode
[RadiusLocalCacheMode]
'Password Local Cache
Timeout'
configure system >
radius settings >
local-cache-timeout
[RadiusLocalCacheTimeout]
'RADIUS VSA Access Level
Attribute'
configure system >
radius settings >
vsa-access-level
[RadiusVSAAccessAttribute]

LDAP Parameters

The Lightweight Directory Access Protocol (LDAP) parameters are described in the table below.
'LDAP Service'
configure system > ldap
settings > ldap-service
[LDAPServiceEnable]
■ For RADIUS login authentication to function, you must
also configure the EnableRADIUS parameter to 1
(Enable).
■ RADIUS authentication requires HTTP basic
authentication, where the username and password are
transmitted in clear text over the network. Therefore, it's
recommended to set the HTTPSOnly parameter to 1 to
force the use of HTTPS, since the transport is encrypted.
Defines the device's mode of operation regarding the timer
(configured by the parameter RadiusLocalCacheTimeout)
that determines the validity of the username and password
(verified by the RADIUS server).
■ [0] Absolute Expiry Timer = When you access a Web
page, the timeout doesn't reset, instead it continues
decreasing.
■ [1] Reset Timer Upon Access = (Default) Upon each
access to a Web page, the timeout always resets (reverts
to the initial value configured by
RadiusLocalCacheTimeout).
Defines the time (in seconds) the locally stored username and
password (verified by the RADIUS server) are valid. When
this time expires, the username and password become invalid
and a must be re-verified with the RADIUS server.
The valid range is 1 to 0xFFFFFF. The default is 300 (5
minutes).
■ [-1] = Never expires.
■ [0] = Each request requires RADIUS authentication.
Defines the code that indicates the access level attribute in
the Vendor Specific Attributes (VSA) section of the received
RADIUS packet.
The valid range is 0 to 255. The default is 35.
Table 72-72:LDAP Parameters
Parameter
Mediant 800 Gateway & E-SBC | User's Manual
Description
Description
Enables the LDAP feature.
■ [0] Disable (default)
■ [1] Enable
Note: For the parameter to take effect, a device
reset is required.
- 1434 -