AudioCodes Mediant 800 User Manual page 1203

CHAPTER 72 Configuration Parameters Reference
[ShortCallSeconds]
configure system > snmp settings
> sys-oid
[SNMPSysOid]
[SNMPTrapEnterpriseOid]
[acUserInputAlarmDescription]
[acUserInputAlarmSeverity]
[AlarmHistoryTableMaxSize]
Parameter
- 1163 -
Mediant 800 Gateway & E-SBC | User's Manual
Description
Defines the duration (in seconds) of a call for
it to be considered a short call and thus,
included in the count of the performance
monitoring SNMP MIBs for short calls
(acPMSBCInShortCallsTable,
acPMSBCOutShortCallsTable,
acPMSBCSRDInShortCallsTable,
acPMSBCSRDOutShortCallsTable,
acPMSBCIPGroupInShortCallsTable, and
acPMSBCIPGroupOutShortCallsTable).
The valid value is 0 to 60. The default is 2. A
value of 0 indicates calls of zero duration,
which are calls that do not pass the device's
Classification, Manipulation or Routing
stages.
Note: The parameter is applicable only to
the SBC application.
Defines the SNMP MIB OID for the base
product system.
The default is 1.3.6.1.4.1.5003.8.1.1.
Note:
■ For the parameter to take effect, a
device reset is required.
■ The device automatically adds the
device's unique product identifier
number at the end of your OID.
Defines the SNMP MIB OID for the Trap
Enterprise.
The default is 1.3.6.1.4.1.5003.9.10.1.21.
Note:
■ For the parameter to take effect, a
device reset is required.
■ The device automatically adds the
device's unique product identifier
number at the end of your OID.
Defines the description of the input alarm.
Defines the severity of the input alarm.
Defines the maximum number of rows in the
Alarm History table. The parameter can be
controlled by the Config Global Entry Limit
MIB (located in the Notification Log MIB).
The valid range is 50 to 1000. The default is
500.
Note: For the parameter to take effect, a
device reset is required.