CHAPTER 69 Testing SIP Signaling Calls
'Play DTMF Method'
play-dtmf-method
[Test_Call_PlayDTMFMethod]
Authentication
Note: These parameters are applicable only if the 'Call Party' parameter (below) is configured to
Caller.
'Auto Register'
auto-register
[Test_Call_AutoRegister]
'Username'
user-name
[Test_Call_UserName]
'Password'
password
[Test_Call_Password]
Test Setting
Parameter
Mediant 800 Gateway & E-SBC | User's Manual
Description
Defines the method used by the devicefor sending DTMF
digits that are played to the called party when the call is
answered.
■
[-1] Not Configured = The mode is according to the
'Alternative DTMF Method' and 'RFC 2833 Mode'
parameters of the IP Profile associated with the rule's
IP Group (see the 'IP Group' parameter above).
■
[0] RFC 2833 = (Default) The device sends the DTMF
digits using the RFC 2833 method (out-of-band).
■
[1] In Band = The device sends the DTMF digits in-
band (in the RTP stream).
Note:
■
The parameter is applicable only if you configure the
'Play' parameter to DTMF.
■
Playing DTMF digits requires DSP resources when
the DTMF method is In Band.
■
If the Test Call sends the SDP offer, the
recommended DTMF configuration of the associated
IP Profile is as follows:
✔
For RFC 2833: 'RFC 2833 Mode' = Extend;
'Alternative DTMF Method' = As Is
✔
For In Band: 'RFC 2833 Mode' = Disallow;
'Alternative DTMF Method' = As Is
■
If the Test Call receives the SDP offer, the
recommended configuration is as follows (i.e.,
incoming SDP offer determines the method): 'RFC
2833 Mode' = As Is; 'Alternative DTMF Method' = As
Is I
Enables automatic registration of the endpoint. The
endpoint can register to the device itself or to the
'Destination Address' or 'IP Group' parameter settings
(see above).
■
[0] Disable (default)
■
[1] Enable
Defines the authentication username.
The valid value is a string of up to 60 characters. By
default, no value is defined.
Defines the authentication password.
By default, no password is defined.
- 1135 -