AudioCodes Mediant 800 User Manual page 1395

Gateways & session border controllers
Hide thumbs Also See for Mediant 800:
Table of Contents

Advertisement

CHAPTER 72    Configuration Parameters Reference
Parameter
'Enable User-to-User IE for
IP to Tel'
uui-ie-for-ip2tel
[EnableUUIIP2Tel]
[Enable911LocationIdIP2T
el]
early-answer-
timeout
[EarlyAnswerTimeout]
Mediant 800 Gateway & E-SBC | User's Manual
Enables interworking of SIP user-to-user information (UUI) to
User-to-User IE in ISDN Q.931 messages.
[0] Disable = (Default) Received UUI is not sent in ISDN
message.
[1] Enable = The device interworks UUI from SIP to ISDN
messages. The device supports the following SIP-to-ISDN
interworking of UUI:
SIP INVITE to Q.931 Setup
SIP REFER to Q.931 Setup
SIP 200 OK to Q.931 Connect
SIP INFO to Q.931 User Information
SIP 18x to Q.931 Alerting
SIP BYE to Q.931 Disconnect
Note:
The interworking of ISDN User-to-User IE to SIP INFO is
applicable only to the Euro ISDN, QSIG, and 4ESS ISDN
variants.
To interwork the UUIE header from SIP-to-ISDN messages
with the 4ESS ISDN variant, the ISDNGeneralCCBehavior
parameter must be set to 16384.
Enables interworking of Emergency Location Identification from
SIP to PRI.
[0] = Disabled (default)
[1] = Enabled
When enabled, the From header received in the SIP INVITE is
translated into the following ISDN IE's:
Emergency Call Control.
Generic Information - to carry the Location Identification
Number information.
Generic Information - to carry the Calling Geodetic Location
information.
Note: The parameter is applicable only to the NI-2 ISDN
variant.
Global parameter that defines the duration (in seconds) that the
device waits for an ISDN Connect message from the called
party (Tel side), started from when it sends a Setup message.
You can also configure this feature per specific calls, using IP
Profiles (IpProfile_EarlyAnswerTimeout). For a detailed
description of the parameter and for configuring this feature in
the IP Profiles table, see
Note: If this feature is configured for a specific IP Profile, the
settings of this global parameter is ignored for calls associated
with the IP Profile.
- 1355 -
Description
Configuring IP
Profiles.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

E-sbc

Table of Contents