AudioCodes Mediant 800 User Manual page 1348

CHAPTER 72 Configuration Parameters Reference
Parameter
'Use Destination As
Connected Number'
configure voip > sip-
definition settings >
use-dst-as-connected-
num
[UseDestinationAsConnecte
dNumber]
'Caller ID Transport Type'
configure voip >
media fax-modem >
caller-ID-transport-
type
[CallerIDTransportType]
Mediant 800 Gateway & E-SBC | User's Manual
■ [1] Add P-Asserted-Identity
■ [2] Add P-Preferred-Identity
The used header also depends on the calling Privacy (allowed
or restricted). These headers are used together with the
Privacy header. If Caller ID is restricted (i.e., P-Asserted-
Identity is not sent), the Privacy header includes the value 'id'
('Privacy: id'). Otherwise, for allowed Caller ID, 'Privacy:
none' is used. If Caller ID is restricted (received from Tel or
for analog interfaces, configured on the device), the From
header is set to <anonymous@anonymous.invalid>.
Digital Interfaces: The 200 OK response can contain the
connected party CallerID - Connected Number and
Connected Name. For example, if the call is answered by the
device, the 200 OK response includes the P-Asserted-
Identity with Caller ID. The device interworks (in some ISDN
variants), the Connected Party number and name from Q.931
Connect message to SIP 200 OK with the P-Asserted-
Identity header. In the opposite direction, if the ISDN device
receives a 200 OK with P-Asserted-Identity header, it
interworks it to the Connected party number and name in the
Q.931 Connect message, including its privacy.
Enables the device to include the Called Party Number, from
outgoing Tel calls (after number manipulation), in the SIP P-
Asserted-Identity header. The device includes the SIP P-
Asserted-Identity header in 180 Ringing and 200 OK
responses for IP-to-Tel calls.
■ [0] Disable (default)
■ [1] Enable
Note:
■ For this feature to function, you also need to enable the
device to include the P-Asserted-Identity header in
180/200 OK responses, by setting the AssertedIDMode
parameter to Add P-Asserted-Identity.
■ If the received Q.931 Connect message contains a
Connected Party Number, this number is used in the P-
Asserted-Identity header in 200 OK response.
■ The parameter is applicable to FXO, ISDN and CAS
interfaces.
Determines the device's behavior for Caller ID detection.
■ [0] Disable = The caller ID signal is not detected - DTMF
digits remain in the voice stream.
■ [1] Relay = (Currently not applicable.)
■ [3] Mute = (Default) The caller ID signal is detected from
the Tel side and then erased from the voice stream.
Note: Caller ID detection is applicable only to FXO
interfaces.
- 1308 -
Description