AudioCodes Mediant 800 User Manual page 568

CHAPTER 20 SIP Definitions
Dial Plan Name
TEL2IP
IP2TEL
2. Open the Routing Settings page (Setup menu > Signaling & Media tab > Gateway folder >
Routing > Routing Settings), and then specify the Dial Plan names that you want to use for
each routing table:
● In the 'IP-to-Tel Dial Plan Name' parameter, enter the name of the Dial Plan (e.g.,
"IP2TEL") that you want to use for IP-to-Tel routing rules.
● In the 'Tel-to-IP Dial Plan Name' parameter, enter the name of the Dial Plan (e.g.,
"TEL2IP") that you want to use for Tel-to-IP routing rules.
Dial Plan names are case-sensitive.
3. Open the Tel-to-IP Routing table (see
then configure a routing rule with the required destination and whose matching characteristics
include the tag(s) that you configured in your Dial Plan for Tel-to-IP routing. The tags are
assigned using the 'Source Tag' and 'Destination Tag' parameters. In our example, configure
two routing rules:
● Routing rule 1:
◆
◆
● Routing rule 2:
◆
◆
Dial Plan Rule
Name
Local1 21[2-4]
Local2
Local3 34[7,9]
Local4 9
[17,29]
Local1
Local2
Local3
Local4
[17,29]
'Destination Tag': NYPSP0
'Destination IP Group': SP-0
'Destination Tag': NYPSP1
'Destination IP Group': SP-1
Mediant 800 Gateway & E-SBC | User's Manual
Prefix Tag
NYPSP0 Denotes local area codes with
prefixes 212, 213, and 214
332 NYPSP0 Denotes local area code with prefix
332
NYPSP1 Denotes local area codes with
prefixes 347 and 349
NYPSP1 Denotes local area codes with pre-
fixes 917 and 929
21[2- NYPSP0 See above
4]
332 NYPSP0 See above
34[7,9 NYPSP1 See above
9 NYPSP1 See above
Configuring Tel-to-IP Routing Rules
- 528 -
Comment
on page 603), and