AudioCodes Mediant 800 User Manual page 1443

CHAPTER 72 Configuration Parameters Reference
'SBC No Answer Timeout'
configure voip > sbc settings >
sbc-no-arelt-timeout
[SBCAlertTimeout]
configure voip > sbc settings >
num-of-subscribes
[NumOfSubscribes]
configure voip > sbc settings >
sbc-dialog-subsc-route-mode
[SBCInDialogSubscribeRouteMode]
Parameter
- 1403 -
Mediant 800 Gateway & E-SBC | User's Manual
Description
Defines the timeout (in seconds) for SBC
outgoing (outbound IP routing) SIP INVITE
messages. If the called IP party does not
answer the call within this user-defined
interval, the device disconnects the
session. The device starts the timeout
count upon receipt of a SIP 180 Ringing
response from the called party. If no other
SIP response (for example, 200 OK) is
received thereafter within this timeout, the
call is released.
The valid range is 0 to 3600 seconds. the
default is 600.
Defines the maximum number of concurrent
SIP SUBSCRIBE sessions permitted on
the device.
The valid value is any value between 0 and
the maximum supported SUBSCRIBE
sessions. When set to -1, the device uses
the default value. For more information,
contact the sales representative of your
purchased device.
Note: For the parameter to take effect, a
device reset is required.
Enables the device to route in-dialog,
refresh SIP SUBSCRIBE requests to the
"working" (has connectivity) proxy.
■ [0] = (Default) Disable – the device
sends in-dialog, refresh SUBSCRIBES
according to the address in the Contact
header of the 200 OK response received
from the proxy to which the initial
SUBSCRIBE was sent (as per the SIP
standard).
■ [1] = Enable – the device routes in-
dialog, refresh SUBSCRIBES to the
"working" proxy (regardless of the
Contact header). The "working" proxy
(address) is determined by the device's
keep-alive mechanism for the Proxy Set
that was used to route the initial
SUBSCRIBE.
Note: For this feature to be functional,
ensure the following:
■ Keep-alive mechanism is enabled for
the Proxy Set ('Proxy Keep-Alive'
parameter is set to any value other than
Disable).