AudioCodes Mediant 800 User Manual page 1433

CHAPTER 72 Configuration Parameters Reference
configure voip > gateway
manipulation settings > use-
refer-by-for-calling-num
[UseReferredByForCallingNumber]
configure voip > gateway
manipulation settings > swap-tel-
to-ip-phone-num
[SwapTel2IPCalled&CallingNumbers]
'Add Prefix to Redirect Number'
add-pref-to-redir-nb
[Prefix2RedirectNumber]
'Add Number Plan and Type to RPI Header'
np-n-type-to-rpi-hdr
[AddTON2RPI]
Parameter
- 1393 -
Mediant 800 Gateway & E-SBC | User's Manual
Description
Note: The parameter is applicable only to
digital interfaces.
Determines whether the device uses the
number from the URI in the SIP Referred-By
header as the calling number in the outgoing
Q.931 Setup message, when SIP REFER
messages are received.
■ [0] = (Default) No
■ [1] = Yes
Note:
■ The parameter is applicable to all ISDN
(TBCT, RLT, ECT) and CAS blind call
transfers (except for in-band) and when
the device receives SIP REFER
messages with a Referred-By header.
■ This manipulation is done before regular
IP-to-Tel source number manipulation.
■ The parameter is applicable only to
digital interfaces.
Global parameter enabling the device to
swap the calling and called numbers
received from the Tel side (for Tel-to-IP
calls).
You can also configure the feature per
specific calls, using Tel Profiles (TelProfile_
SwapTelToIpPhoneNumbers). For a
detailed description of the parameter and for
configuring the feature in the Tel Profiles
table, see Configuring Tel
Note: If the feature is configured for a
specific Tel Profile, the settings of the global
parameter is ignored for calls associated
with the Tel Profile.
Defines a string prefix that is added to the
Redirect number received from the Tel side.
This prefix is added to the Redirect Number
in the SIP Diversion header.
The valid range is an 8-character string. By
default, no value is defined.
Note: The parameter is applicable only to
digital interfaces.
Determines whether the TON/PLAN
parameters are included in the Remote-
Party-ID (RPID) header.
■ [0] No
■ [1] Yes (default)
Profiles.