AudioCodes Mediant 800 User Manual page 660

CHAPTER 25 Routing
■ Enables Least Cost Routing (LCR), and defines default call cost (highest or lowest) and
average call duration for Tel-to-IP routing rules that are not assigned LCR Cost Groups. The
default call cost determines whether matched routing rules that are not assigned a Cost Group
are considered as a higher or lower cost route compared to other matching routing rules that are
assigned Cost Groups. If you disable LCR, the device ignores the Cost Groups assigned to
Tel-to-IP routing rules in the Tel-to-IP Routing table. LCR is applicable only to Tel-to-IP routing.
The following procedure describes how to configure Routing Policy rules through the Web interface.
You can also configure it through ini file [GwRoutingPolicy] or CLI ( configure voip >
gateway routing gw-routing-policy).
➢
To edit the Routing Policy rule:
1. Open the Routing Policies table (Setup menu > Signaling & Media tab > Gateway folder >
Routing > Routing Policies).
2. Click New; the following dialog box appears:
3. Configure the Routing Policy rule according to the parameters described in the table below.
4. Click Apply.
Table 25-5: Routing Policies Table Parameter Descriptions
Parameter
'Index'
[GwRoutingPolicy_Index]
'Name'
name
[GWRoutingPolicy_
Name]
'LDAP Servers Group
Name'
ldap-srv-group-
name
[GWRoutingPolicy_
LdapServersGroupName]
Mediant 800 Gateway & E-SBC | User's Manual
(Read-only) Displays the index number of the table row.
Defines a descriptive name, which is used when associating the
row in other tables.
The valid value is a string of up to 40 characters.
The default value is "GwRoutingPolicy".
Assigns an LDAP Server Group to the Routing Policy. IP-to-Tel
and Tel-to-IP routing rules that require LDAP-based routing
(and/or Call Setup Rules) use the LDAP server(s) assigned to the
LDAP Server Group.
By default, no value is defined.
For more information on LDAP Server Groups, see
LDAP Server Groups.
- 620 -
Description
Configuring