CHAPTER 58 Viewing VoIP Status
58
Viewing VoIP Status
This section describes how to view VoIP-related status.
Viewing Tel-IP Call Counters
You can view statistical information on IP-to-Tel and Tel-to-IP calls in the Web interface's IP to Tel
Calls Count page and Tel to IP Calls Count page. The information is updated according to the
release reason that is received after a call is terminated (during the same time as the end-of-call
CDR message is sent). The release reason can be viewed in the 'Termination Reason' field in the
CDR message.
You can reset the statistical data displayed on the page (i.e., refresh the display), by clicking the
Reset Counters button located below the table.
➢
To view IP-to-Tel and Tel-to-IP call counters:
■
Open the IP to Tel Calls Count page or Tel to IP Calls Count page (Monitor menu > Monitor
tab > VoIP Status folder > IP to Tel Calls Count or Tel to IP Calls Count); the figure below
shows the IP to Tel Calls Count page.
The fields in this page are described in the following table:
Table 58-1: IP to Tel Calls Count and Tel to IP Calls Count Description
Counter
Number of
Attempted
Calls
Number of
Established
Calls
Indicates the number of attempted calls. It is composed of established and
failed calls. The number of established calls is represented by the 'Number of
Established Calls' counter. The number of failed calls is represented by the
failed-call counters. Only one of the established / failed call counters is
incremented every time.
Indicates the number of established calls. It is incremented as a result of one
of the following release reasons if the duration of the call is greater than zero:
■
GWAPP_REASON_NOT_RELEVANT (0)
■
GWAPP_NORMAL_CALL_CLEAR (16)
■
GWAPP_NORMAL_UNSPECIFIED (31)
And the internal reasons:
■
RELEASE_BECAUSE_UNKNOWN_REASON
■
RELEASE_BECAUSE_REMOTE_CANCEL_CALL
■
RELEASE_BECAUSE_MANUAL_DISC
■
RELEASE_BECAUSE_SILENCE_DISC
■
RELEASE_BECAUSE_DISCONNECT_CODE
- 1012 -
Mediant 800 Gateway & E-SBC | User's Manual
Description