AudioCodes Mediant 800 User Manual page 626

CHAPTER 23 Digital PSTN
➢
To configure private wire interworking:
1. Enable TDM tunneling for private wire services, by doing one of the following:
● Globally: Open the Digital Gateway Parameters page (Setup menu > Signaling &
Media tab > Gateway folder > Digital Gateway > Digital Gateway Parameters), and
then from the 'TDM Tunneling' drop-down list, select Private Wire:
● Per Trunk: Configure the ini file parameter EnableTDMOverIPforTrunk.
2. Configure the ini file parameter EnableReansweringInfo to 1.
3. Load a CAS table file that supports your private wire service. For loading files to the device,
see Loading Auxiliary
4. In the Trunk Settings page (see
Trunk. Make sure that you select the CAS table file that you loaded in the previous step, in the
'CAS Table per Trunk' field:
5. In the Trunk Group table (see
E1/T1 CAS Trunk, as shown in the following example:
6. In the Trunk Group Settings table (see
method for selecting channels for the E1/T1 CAS Trunk to By Dest Phone Number, as
shown in the following example:
7. In the IP-to-Tel Routing table (see
Routing rules.
Files.
Configuring Trunk
Configuring Trunk
Configuring
Configuring IP-to-Tel Routing
- 586 -
Mediant 800 Gateway & E-SBC | User's Manual
Settings), configure your E1 or T1 CAS
Groups), configure the Trunk Group ID for the
<trnkgrpsettable<product>>), configure the
Rules), configure IP-to-Tel