Isdn Parameters - AudioCodes Mediant 800 User Manual

CHAPTER 72 Configuration Parameters Reference
'DTMF Min Detection Time'
[CASStateMachineDTMFMinOnDetectionTime]
'MAX Incoming Address Digits'
[CASStateMachineMaxNumOfIncomingAddress
Digits]
'MAX Incoming ANI Digits'
[CASStateMachineMaxNumOfIncomingANIDigi
ts]
'Collect ANI'
[CASStateMachineCollectANI]
'Digit Signaling System'
[CASStateMachineDigitSignalingSystem]

ISDN Parameters

The ISDN parameters are described in the table below.
Parameter
- 1342 -
Mediant 800 Gateway & E-SBC | User's Manual
Description
The value must be a positive value. The
default is -1.
Detects digit minimum on time (according
to DSP detection information event) in
msec units. The digit time length must be
longer than this value to receive a
detection. Any number may be used, but
the value must be less than
CasStateMachineDTMFMaxOnDetection
Time.
The value must be a positive value. The
default is -1.
Defines the limitation for the maximum
address digits that need to be collected.
After reaching this number of digits, the
collection of address digits is stopped.
The value must be an integer. The default
is -1.
Defines the limitation for the maximum
ANI digits that need to be collected. After
reaching this number of digits, the
collection of ANI digits is stopped.
The value must be an integer. The default
is -1.
In some cases, when the state machine
handles the ANI collection (not related to
MFCR2), you can enable the state
machine to collect ANI or discard ANI.
■ [0] No = Don't collect ANI.
■ [1] Yes = Collect ANI.
■ [-1] Default = Default value.
Defines which Signaling System to use in
both directions (detection\generation).
■ [0] DTMF = DTMF signaling.
■ [1] MF = (Default) MF signaling.
■ [-1] Default = Default value.