AudioCodes Mediant 800 User Manual page 1394

CHAPTER 72 Configuration Parameters Reference
Parameter
'AoC Support'
configure voip >
gateway dtmf-supp-
service supp-
service-settings >
aoc-support
[EnableAOC]
'Add IE in SETUP'
add-ie-in-setup
[AddIEinSetup]
'Trunk Groups to Send IE'
trkgrps-to-snd-ie
[SendIEonTG]
'Enable User-to-User IE for
Tel to IP'
uui-ie-for-tel2ip
[EnableUUITel2IP]
Mediant 800 Gateway & E-SBC | User's Manual
■ [1] = Enabled - CIC (received in the INVITE Request-URI) is
relayed to the ISDN in the Transit Network Selection (TNS)
IE of the Setup message. For example: INVITE
sip:555666;cic=2345@100.2.3.4 sip/2.0.
Note:
■ This feature is supported only for SIP-to-ISDN calls.
■ The parameter AddCicAsPrefix can be used to add the CIC
as a prefix to the destination phone number for routing IP-to-
Tel calls.
Enables the interworking of ISDN Advice of Charge (AOC)
messages to SIP.
■ [0] Disable (default)
■ [1] Enable
For more information on AOC, see
for Euro ISDN.
Global parameter that defines an optional Information Element
(IE) data (in hex format) to add to ISDN Setup messages. You
can also configure this feature per specific calls, using IP
Profiles (IpProfile_AddIEInSetup). For a detailed description of
the parameter and for configuring this feature in the IP Profiles
table, see Configuring IP
Note: If this feature is configured for a specific IP Profile, the
settings of this global parameter is ignored for calls associated
with the IP Profile.
Defines Trunk Group IDs (up to 50 characters) from where the
optional ISDN IE (defined by the parameter AddIEinSetup) is
sent. For example: '1,2,4,10,12,6'.
Note:
■ You can configure different IE data for Trunk Groups by
defining the parameter for different IP Profile IDs (using the
parameter IPProfile), and then assigning the required IP
Profile ID in the IP-to-Tel Routing table (PSTNPrefix).
■ When IP Profiles are used for configuring different IE data
for Trunk Groups, the parameter is ignored.
Enables transfer of User-to-User (UU) IE from ISDN to SIP.
■ [0] Disable (default)
■ [1] Enable
The device supports the following ISDN-to-SIP interworking:
Setup to SIP INVITE, Connect to SIP 200 OK, User Information
to SIP INFO, Alerting to SIP 18x response, and Disconnect to
SIP BYE response messages.
Note: The interworking of ISDN User-to-User IE to SIP INFO is
applicable only to the Euro ISDN, QSIG, and 4ESS ISDN
variants.
- 1354 -
Description
Advice of Charge Services
Profiles.