AudioCodes Mediant 800 User Manual page 1452

CHAPTER 72 Configuration Parameters Reference
configure voip > sbc settings >
enforce-media-order
[SBCEnforceMediaOrder]
'SBC Diversion URI Type'
configure voip > sbc settings >
sbc-diversion-uri-type
[SBCDiversionUriType]
configure voip > sbc settings >
sbc-server-auth-mode
[SBCServerAuthMode]
Parameter
- 1412 -
Mediant 800 Gateway & E-SBC | User's Manual
Description
Note: If this feature is configured for a
specific IP Profile, the settings of this global
parameter is ignored for calls associated
with the IP Profile.
Enables the device to include all previously
negotiated media lines within the current
session ('m=' line) in the SDP offer-answer
exchange (RFC 3264).
■ [0] = (Default) Disable
■ [1] = Enable
For example, assume a call (audio) has
been established between two endpoints
and one endpoint wants to subsequently
send an image in the same call session. If
the parameter is enabled, the endpoint
includes the previously negotiated media
type (i.e., audio) with the new negotiated
media type (i.e., image) in its SDP offer:
v=0
o=bob 2890844730 2890844731 IN
IP4 host.example.com
s=
c=IN IP4 host.example.com
t=0 0
m=audio 0 RTP/AVP 0
m=image 12345 udptl t38
If the parameter is disabled, the only 'm='
line included in the SDP is the newly
negotiated media (i.e., image).
Defines the URI type to use in the SIP
Diversion header of the outgoing SIP
message.
■ [0] Transparent = (Default) The device
does not change the URI and leaves it
as is.
■ [1] Sip = The "sip" URI is used.
■ [2] Tel = The "tel" URI is used.
Note: The parameter is applicable only if
the Diversion header is used. The
SBCDiversionMode and
SBCHistoryInfoMode parameters in the IP
Profiles table determine the call redirection
(diversion) SIP header to use - History-Info
or Diversion.
Defines whether authentication of the SIP
client is done locally (by the device) or by a
RADIUS server.