AudioCodes Mediant 800 User Manual page 597

CHAPTER 23 Digital PSTN
Parameter
'Outgoing Calls Behavior'
configure voip >
interface e1-t1
bri > isdn-bits-
outgoing-calls-
behavior
[ISDNOutCallsBehavior]
Mediant 800 Gateway & E-SBC | User's Manual
■ [1073741824] QSI ENCODE INTEGER = If this bit is set,
INTEGER ASN.1 type is used in operator coding
(compliant to new ECMA standards); otherwise, OBJECT
IDENTIFIER ASN.1 type is used.
Note: This option is applicable only to QSIG.
■ [2147483648] 5ESS National Mode For Bch
Maintenance = Use the National mode of AT&T 5ESS for
B-channel maintenance.
Note:
■ If you are modifying the parameter for an existing
(configured) trunk through the Web interface, you must
first stop the trunk.
■ To configure the device to support several ISDNIBehavior
features, enter a summation of the individual feature
values. For example, to support both [512] and [2048]
features, set the parameter ISDNIBehavior is set to 2560
(i.e., 512 + 2048).
■ When configuring through the Web interface, to select the
options click the arrow button and then for each required
option select 1 to enable.
■ For BRI terminal endpoint identifier (TEI) configuration,
instead of using the ISDNIBehavior parameter, use the
following parameters: BriTEIConfigP2P_x,
BriTEIConfigP2MP_x, BriTEIAssignTrigger_x, and
BriTEIRemoveTrigger_x.
Defines (by bit-field) several options that influence the
behavior of the ISDN Stack outgoing calls. To select options,
click the arrow button, and then for each required option,
select 1 to enable. The default is 0 (i.e., disable).
■ [2] USER SENDING COMPLETE =The default behavior
of the device (when this bit is not set) is to automatically
generate the Sending-Complete IE in the Setup message.
This behavior is used when overlap dialing is not needed.
When overlap dialing is needed, set this bit and the
behavior is changed to suit the scenario, i.e., Sending-
Complete IE is added when required in the Setup message
for Enblock mode or in the last Digit with Overlap mode.
■ [16] USE MU LAW = The device sends G.711-m-Law in
outgoing voice calls. When disabled, the device sends
G.711-A-Law in outgoing voice calls.
Note: This option is applicable only to the Korean variant.
■ [128] DIAL WITH KEYPAD = The device uses the
Keypad IE to store the called number digits instead of the
CALLED_NB IE.
Note: This option is applicable only to the Korean variant
(Korean network). This is useful for Korean switches that
don't accept the CALLED_NB IE.
- 557 -
Description