Services; Sip-Based Media Recording Parameters - AudioCodes Mediant 800 User Manual

CHAPTER 72 Configuration Parameters Reference
[PDPattern]
[PDThreshold]

Services

This section describes services-related parameters.

SIP-based Media Recording Parameters

The SIP-based media recording parameters are described in the table below.
Parameter
'SIP Recording Application'
configure voip > sip-
definition sip-
recording settings >
enable-sip-rec
[EnableSIPRec]
'Recording Server (SRS)
Destination Username'
configure voip > sip-
definition sip-
recording settings >
siprec-server-dest-
username
[SIPRecServerDestUsername]
'SIP Recording Metadata
Format'
configure voip > sip-
definition sip-
recording settings >
siprec-metadata-format
[SIPRecMetadataFormat]
Parameter
Table 72-69:SIP-based Media Recording Parameters
Enables the SIP-based Media Recording feature:
■
■
Note: For the parameter to take effect, a device reset is
required.
Defines the SIP user part for the recording server. This user
part is added in the SIP To header of the INVITE message
that the device sends to the recording server.
The valid value is a string of up to 50 characters. By
default, no user part is defined.
Defines the format of the SIPRec recording metadata that
the device generates in SIP messages sent to the SRS.
■
Mediant 800 Gateway & E-SBC | User's Manual
Description
Defines the patterns that can be detected by the
Pattern Detector.
The valid range is 0 to 0xFF.
Note: For the parameter to take effect, a device reset
is required.
Defines the number of consecutive patterns to trigger
the pattern detection event.
The valid range is 0 to 31. The default is 5.
Note: For the parameter to take effect, a device reset
is required.
Description
[0] Disable (default)
[1] Enable
[0] Legacy = (Default) The device generates the
recording metadata in a "legacy" format, whereby the
user part of the participant URI (source or destination)
is used as the ID.
- 1430 -