AudioCodes Mediant 800 User Manual page 1410

CHAPTER 72 Configuration Parameters Reference
'Analog Metering Type'
configure voip >
interface fxs-fxo >
metering-type
[MeteringType]
'Analog TTX Voltage Level'
[AnalogTTXVoltageLevel ]
Parameter
Mediant 800 Gateway & E-SBC | User's Manual
Description
■ [3] SIP RAW Data Provided = (Proprietary method
of Cirpack) Advice-of-Charge service toward the
PSTN. The received AOC-D messages contain a
subtotal. When receiving AOC-D in raw format,
provided in the header of SIP INFO messages, the
device parses AOC-D raw data to obtain the number
of units. This number is sent in the Facility message
with AOC-D. In addition, the device stores the latest
number of units in order to send them in AOC-E IE
when the call is disconnected.
Note: This option is applicable only to digital inter-
faces.
■ [4] SIP RAW Data Incremental Provided =
(Proprietary method of Cirpack) Advice-of-Charge
service toward the PSTN. The AOC-D message in
the payload is an increment. When receiving AOC-D
in raw format, provided in the header of SIP INFO
messages, the device parses AOC-D raw data to
obtain the number of units. This number is sent in the
Facility message with AOC-D. The device generates
the AOC-E. Parsing every AOC-D received and
summing the values is required to obtain the total sum
(that is placed in the AOC-E).
Note: This option is applicable only to digital inter-
faces.
■ [5] SIP-to-Tel Interworking = Enables IP-to-Tel
AOC, using the AudioCodes proprietary SIP header,
AOC.
Note: This option is applicable only to digital inter-
faces.
Note: The parameter is applicable only to FXS and ISDN
Euro trunks for sending AOC Facility messages (see
Advice of Charge Services for Euro
Defines the metering method for generating pulses
(sinusoidal metering burst frequency) by the FXS port.
■ [0] 12 KHz sinusoidal bursts (default)
■ [1] 16 kHz sinusoidal bursts
■ [2] Polarity Reversal pulses
Note:
■ For the parameter to take effect, a device reset is
required.
■ The parameter is applicable only to FXS interfaces.
Determines the metering signal/pulse voltage level (TTX).
■ [0] 0V = 0 Vrms sinusoidal bursts.
■ [1] 0.5V = (Default) 0.5 Vrms sinusoidal bursts.
■ [2] 1V = 1 Vrms sinusoidal bursts
- 1370 -
ISDN).