Isdn And Cas Interworking Parameters - AudioCodes Mediant 800 User Manual

CHAPTER 72 Configuration Parameters Reference
configure voip > interface
bri > tei-remove-trigger
[BriTEIRemoveTrigger_x]

ISDN and CAS Interworking Parameters

The ISDN and CAS interworking parameters are described in the table below.
Parameter
ISDN Parameters
'Send Local Time To ISDN
Connect'
[SendLocalTimeToISDNC
onnect]
Parameter
Table 72-56:ISDN and CAS Interworking Parameters
Determines the device's handling of the date and time sent in
the ISDN Connect message (Date / Time IE) upon receipt of
SIP 200 OK messages.
■ [0] Disable = (Default) If the SIP 200 OK includes the Date
header, the device sends its value in the ISDN Connect
Date / Time IE. If the 200 OK does not include this header, it
does not add the Date / Time IE to the sent ISDN Connect
message.
■ [1] Enable = If the SIP 200 OK includes the Date header,
the device sends its value (i.e. date and time) in the ISDN
Connect Date / Time IE. If the 200 OK does not include this
header, the device uses its internal, local date and time for
the Date / Time IE, which it adds to the sent ISDN Connect
message.
■ [2] Always Send Local Date and Time = The device
always sends its local date and time (obtained from its
internal clock) to PBXs in ISDN Q.931 Connect messages
(Date / Time IE). It does this regardless of whether or not the
incoming SIP 200 OK includes the Date header. If the SIP
200 OK includes the Date header, the device ignores its
value.
Note:
■ This feature is applicable only to Tel-to-IP calls.
Mediant 800 Gateway & E-SBC | User's Manual
Description
■ Bit #0: BRI Layer 1 (physical) is activated.
■ Bit #1: BRI port configuration has completed.
■ Bit #2: Call setup is initiated.
The default is 0x04 (Bit #2).
Note: The parameter is applicable only to the User
side and for dynamic TEI assignment.
Defines when to clear existing dynamic TEI(s)
assignment.
The valid values are (bit-field parameter):
■ Bit #0: BRI layer 1 is deactivated (disconnected).
■ Bit #1: BRI Layer 2 (data link) is released
(disconnected).
The default is 0x00 (no one bit is configured).
Description
- 1345 -