AudioCodes Mediant 800 User Manual page 849

CHAPTER 34 Routing SBC
b. From the 'CNG Detector Mode' drop-down list [CNGDetectorMode], select Event Only.
2. Load an ini file to the device through the Auxiliary Files page (see
through Web Interface
band network detection related to fax:
EnableFaxModemInbandNetworkDetection = 1
3. In the IP Groups table (see
● IP Group #0 "HQ": This is the source IP Group, sending voice calls and fax calls.
● IP Group #1 "Voice": This is the destination for voice calls sent from IP Group #0.
● IP Group #2 "Fax": This is the destination for fax calls sent from IP Group #0.
4. For the fax destination (IP Group #2), do the following:
a. In the Coder Groups table (see
T.38 to enable fax transmission over IP.
b. In the IP Profiles table (see
i.
ii.
c. In the IP Groups table, edit IP Group #2, and then from the 'IP Profile' drop-down list,
select the IP Profile that you configured above.
5. For the voice destination (IP Group #1), do the following:
a. In the IP Profiles table, configure an IP Profile - from the 'Fax Rerouting Mode' drop-down
list, select Rerouting without delay:
b. In the IP Groups table, edit IP Group #1, and then from the 'IP Profile' drop-down list,
select the IP Profile that you configured above.
6. In the IP-to-IP Routing table (see
following adjacent rows of IP-to-IP Routing rules:
● IP-to-IP Routing Rule #0 to route voice calls from IP Group #0 to IP Group #1:
Match
Source IP Group
Call Trigger
ReRoute IP Group
Action
Destination Type
Destination IP Group
● IP-to-IP Routing Rule #1 to route fax calls from IP Group #0 to IP Group #2:
Match
Source IP Group
on page 917) with the following parameter setting, which enables in-
Configuring IP
Configuring IP
From the 'Fax Coders Group' drop-down list, select the Coder Group that you
configured above.
From the 'Fax Mode' drop-down list, select Handle always.
Mediant 800 Gateway & E-SBC | User's Manual
Groups), configure the following IP Groups:
Configuring Coder Groups), configure a Coder Group with
Profiles), configure an IP Profile:
Configuring SBC IP-to-IP Routing
HQ (IP Group #0)
Initial Only
Voice (IP Group #1)
IP Group
Voice (IP Group #1)
HQ (IP Group #0)
- 809 -
Loading Auxiliary Files
Rules), configure the