AudioCodes Mediant 800 User Manual page 898

CHAPTER 37 Advanced SBC Features
2. Configure the keep-alive interval with the WebSocket client:
a. On the Transport Settings page (Setup menu > Signaling & Media tab > SIP
Definitions folder > Transport Settings), and then in the 'WebSocket Keep-Alive Period'
field (WebSocketProtocolKeepAlivePeriod), enter the keep-alive interval:
b. Click Apply.
3. Configure a SIP Interface for the WebRTC clients that identifies WebSocket traffic:
a. Open the SIP Interfaces table (see
b. Do the following:
◆
◆
◆
c. Click Apply.
4. Configure an IP Profile for the WebRTC clients:
a. Open the IP Profiles table (see
b. Do the following:
◆
◆
◆
From the 'Encapsulating Protocol' drop-down list (SIPInterface_
EncapsulatingProtocol), select WebSocket.
In the 'TLS Port' field, configure the TLS port.
From the 'TLS Context Name' drop-down list, assign the TLS Context that you
configured in Step 1 (e.g., "WebRTC").
From the 'ICE Mode' drop-down list (IPProfile_SBCIceMode), select Lite to enable
ICE.
From the 'RTCP Mux' drop-down list (IPProfile_SBCRTCPMux), select Supported
to enable RTCP multiplexing.
From the 'RTCP Feedback' drop-down list (IPProfile_SBCRTCPFeedback), select
Feedback On to enable RTCP feedback.
Mediant 800 Gateway & E-SBC | User's Manual
Configuring SIP Interfaces).
Configuring IP Profiles).
- 858 -