How To Switch Run/Stop; Set Parameter - Rievtech xLogic ELC Series User Manual

4.3.1 How to switch Run/Stop

You should first select FUNCTION PAGE. (Read 4.3)
1. Move the cursor to "Run/stop": Press "UP" or "DOWN" key.
2. Move the cursor to "Yes": Press OK key.
After pressing ESC key, you'll find out your circuit program has changed to "stop" status as figure below
shows:

4.3.2 Set parameter

If you want to select a parameter, you need do as the following procedures:
1. Under the FUNCTION PAGE, select
"Set parameter": Press or key
44