A/C System Relay Inspection; Compressor Drive Belt Inspection And Adjustment - Suzuki 2006 SX4 Service Manual

7B-30 Air Conditioning System: Manual Type

A/C System Relay Inspection

NOTE
Do not use blue relay for the substitute of
white relay because internal durability of a
blue relay is different from the durability of a
white relay.
1) Disconnect negative (–) cable from battery.
2) Remove compressor relay (1) or condenser cooling
fan relay (2) from main fuse box (3).
3) Check that there is no continuity between terminal
"c" and "d". If there is continuity, replace relay.
4) Connect battery positive (+) terminal to terminal "b"
of relay and battery negative (–) terminal to terminal
"a" of relay, and then check continuity between
terminal "c" and "d". If there is no continuity, replace
relay.
"a"
"b"
S6RW0D7216017
3
1
2
"c"
"d"
I5RW0B721023-01
Compressor Drive Belt Inspection and
Adjustment
Inspection
• Check compressor drive belt (1) for wear, crack,
deformation and cleanliness. If any defect is found,
replace the belt with new one referring to
"Compressor Drive Belt Removal and Installation".
• Check compressor drive belt tension by measuring
how much it deflects when pushed intermediate point
between magnet clutch pulley (6) and crankshaft
pulley (3) with about 100 N (10 kg) force after rotating
crankshaft pulley 360°. If belt tension is out of
specification, adjust belt tension referring to
"Adjustment".
Compressor drive belt tension "a"
: 7 – 8 mm (0.28 – 0.31 in.)
NOTE
When replacing drive belt, adjust drive belt
tension to the following specifications.
New compressor drive belt tension "a"
: 6 – 7 mm (0.24 – 0.28 in.)
Adjustment
1) Loosen tension pulley nut (4).
2) Adjust belt tension by tighten or loosen tension
pulley adjusting bolt (5).
3) Tighten tension pulley nut.
4) Rotate the crankshaft pulley 360°, and then recheck
belt tension.
2. Tension pulley
S6RW0D7216018
I5RW0A721033-01