Rear Wheel Bearing; Bolts And Nuts - Suzuki Samurai 1986 Service Manual

2) Cut oil seal in place with scissors or a knife,
and take it off.
3) Cut replacement oil seal at one place with
scissors or a knife as shown in below figure.
4) Install the seal in oil seal retainer, bringing
the cut portion to top side and locating it
about 30 degrees off the matching face of
oil seal retainer.
Fig. 17-3-16
5) Apply grease to inside of oil seal. Apply
sealing compound to mating face all around:
this is for preventing entry of water.
. SEALING COMPOUND "CEMEDINE"
366E (99000-31090)
. SUZUKI SUPER GREASE H
99000-25120).
Apply grease
,
Fig. 17-3-17
6) Tighten joint seat securing bolts to specified
torque.
17-24
Apply sealer

Rear Wheel Bearing

1) Check wheel bearings for wear. When measur-
ing thrust play, apply a dial gauge to drum
center.
Thrust play Limit Rear
Fig. 17-3-18
When measurement exceeds limit, replace
bearing.
2) By rotating wheel actually, check wheel
bearing for noise and smooth rotation. If it
is defective, replace bearing.

Bolts and Nuts

Check following bolts and nuts for tighteness
and retighten them to specified torque as
necessary.
Fastening parts
0.8 mm (0.03 in.)
Tightening torque
Refer to "RECOM-
MENDED TORQUE
SPECIFICATIONS"
in this section