Subaru Legacy 2004 Service Manual page 1313

ENGINE (DIAGNOSTICS)
5. READ CURRENT DATA FOR ENGINE (OBD MODE)
1) On the «Main Menu» display screen, select the {Each System Check} and press the [YES] key.
2) On the «System Selection Menu» display screen, select the {Engine} and press the [YES] key.
3) Press the [YES] key after the information of engine type was displayed.
4) On the «Engine Diagnosis» display screen, select the {OBD System} and press the [YES] key.
5) On the «OBD Menu» screen, select the {Current Data Display/Save}, and then press the [YES] key.
6) On the «Data Display Menu» screen, select the {Data Display} and press the [YES] key.
7) Using the scroll key, move the display screen up or down until the desired data is shown.
• A list of the support data is shown in the following table.
Number of diagnosis code
Condition of malfunction indicator light
Monitoring test of misfire
Monitoring test of fuel system
Monitoring test of comprehensive component
Test of catalyst
Test of heating-type catalyst
Test of evaporative emission purge control system
Test of secondary air system
Test of air conditioning system refrigerant
Test of oxygen sensor
Test of oxygen sensor heater
Test of EGR system
NOTE:
For detailed operation procedure, refer to the "SUBARU SELECT MONITOR OPERATION MANUAL".
Subaru Select Monitor
Description
EN(H4DOTC)(diag)-24
Display
Number of Diag. Code:
MI (MIL)
Misfire monitoring
Fuel system monitoring
Component monitoring
Catalyst Diagnosis
Heated catalyst
Evaporative purge system
Secondary air system
A/C system refrigerant
Oxygen sensor
O2 Heater Diagnosis
EGR system
Unit of measure
—
ON or OFF
no support
complete or incomplete
complete or incomplete
no support
no support
no support
no support
no support
complete or incomplete
complete or incomplete
no support