Knock Sensor - Mazda RX-8 Manual

KNOCK SENSOR

KNOCK SENSOR (KS) REMOVAL/INSTALLATION
1. Disconnect the KS connector.
2. Remove the KS installation bolt and remove the KS.
3. Install in the reverse order of removal.
KS tightening torque
1525 N·m {1.62.5 kgf·m, 1218 ft·lbf}
o
KNOCK SENSOR (KS) INSPECTION
Resistance Inspection
NOTE:
Before performing the following inspection, make sure to follow the troubleshooting flowchart. (See
•
FOREWORD .)
1. Disconnect the KS connector.
2. Measure the resistance between KS terminals A and B.
If not within the specification, replace the KS. (See KNOCK SENSOR (KS)
•
REMOVAL/INSTALLATION .)
(w) Engine Specifications
Page 314