Table of Contents
Advertisement
2 System Overview
You should read this section of the Manual before you unpack or install the 440 System.
This section tells you about the important checks and inspections that you should make when you first
receive the Teledyne TSS 440 System. It also includes a brief description of the main items supplied as
standard with the System.
If you need to order replacement parts for your system please include a full description of the parts
required as well as the part number and the serial number of the relevant sub-assembly.
Scope of Delivery
The 440 System includes various sub-assemblies that you must interconnect properly before the
System will work.
Figure 2-1
shows a typical stand-alone configuration for the 440 System that has the SDC installed on
a surface vessel and the sub-sea components mounted on the ROV.
components of the installation.
Optionally, you may use the 440 System as part of a Dualtrack installation. In this mode, a single SDC
controls the operation of the 440 Pipe and Cable Survey System when its sub-sea components are
connected to either a Teledyne TSS 350 or 350 Powertrack Cable Survey System. See
"Dualtrack System" on page B-1
within a Dualtrack installation.
A A
AC Input
Power
Supply
H
G
J
Figure 2-1: Components of the 440 System
DPN 402196 Issue 4.1
for instructions on how to connect and configure the 440 System
B
F
E
I
© Teledyne TSS
2 – System Overview
Table 2-1
identifies the individual
ROV umbilical (user supplied)
Communications
D
C
Electrical
Supply
section B.1
2- 1
Advertisement
Table of Contents
