Detailed Messages Of The Slave Diagnostics - Siemens SIMOCODE pro Function Manual

3.3.1.4

Detailed messages of the slave diagnostics

The following table contains the detailed messages of the slave diagnostics for status
information and the hardware interrupt. This information is also contained in data record 92.
Note
Structure of the slave diagnostics
The diagnostic messages listed below are the same as those contained in the hardware
interrupts transferred via PROFIBUS. See also Chapter "Structure of the slave
diagnostics → Hardware interrupt - Structure" in the SIMOCODE pro – System Manual
(https://support.industry.siemens.com/cs/ww/en/view/109743957).
Table 3- 22 Detailed messages of the slave diagnostics
Byte.Bit Status message
0.0 Faults - control
0.1
0.2
0.3
0.4
0.5
0.6
0.7
1.0
1.1
1.2
1.3
1.4
2.0
2.1 Faults - Protection
2.2
2.3
2.4
2.5
2.6
2.7
3.0
3.1
3.2
3.3
3.4
3.5
3.6
SIMOCODE pro - Communication
Function Manual, 11/2018, A5E40508495002A/RS-AC/003
Fault - execution ON command
Fault - execution STOP command
Fault - feedback (FB) ON
Fault - feedback (FB) OFF
Fault - stalled positioner
Fault - double 0
Fault - double 1
Fault - end position
Fault - antivalence
Fault - Cold start (TPF) fault
Fault - power failure (UVO)
Fault - Operational Protection Off (OPO)
Reserved
Reserved
Fault - unbalance
Fault - overload
Fault - overload + phase failure
Fault - int. ground fault
Fault - ext. ground fault
Reserved
Fault - thermistor overload
Fault - thermistor short circuit
Fault - thermistor open circuit
Reserved
Fault - TM trip T>
Fault - TM sensor fault
Fault - TM out of range
Fault - EM+ open circuit
Tables, data records
3.3 Tables, PROFIBUS data records
Information
BU0 BU1 BU2(+)
BU0 BU1 BU2(+)
BU0 BU1 BU2(+)
BU0 BU1 BU2(+)
BU2(+)
BU2(+)
BU2(+)
BU2(+)
BU2(+)
BU0 BU1 BU2(+)
BU2(+)
BU2(+)
IM UM
IM UM
IM UM
IM UM
EM
Th
Th
Th
TM MM
TM MM
TM MM
MM EM+
153