Pole-Changing Reversing Starter - Siemens SIMOCODE pro Function Manual

3.2.10

Pole-changing reversing starter

Table 3- 13 Assignment of cyclic receive / send data, pole-changing reversing starter
Cyclic receive data
Bit 0.0
Bit 0.1
Bit 0.2
Bit 0.3
Bit 0.4
Bit 0.5
Bit 0.6
Bit 0.7
Bit 1.0
Bit 1.1
Bit 1.2
Bit 1.3
Bit 1.4
Bit 1.5
Bit 1.6
Bit 1.7
Byte 2/3 *) (analog value)
Cyclic send data
Bit 0.0
Bit 0.1
Bit 0.2
Bit 0.3
Bit 0.4
Bit 0.5
Bit 0.6
Bit 0.7
Bit 1.0
Bit 1.1
Bit 1.2
Bit 1.3
Bit 1.4
Bit 1.5
Bit 1.6
Bit 1.7
Byte 2/3 (analog value)
Byte 4/5 *) (analog value)
Byte 6/7 *) (analog value)
Byte 8/9 *) (analog value)
*) for SIMOCODE pro V / pro S, basic type 1 only
SIMOCODE pro - Communication
Function Manual, 11/2018, A5E40508495002A/RS-AC/003
3.2 Assignment of cyclic receive and send data for predefined control functions
Device parameters → Motor control → Control stations → PLC/PCS [DP] → ON >>
Device parameters → Motor control → Control stations → PLC/PCS [DP] → OFF
Device parameters → Motor control → Control stations → PLC/PCS [DP] → ON >
Further function blocks → Standard functions → Test / Reset → Test1 - Input
Further function blocks → Standard functions → Emergency start → Emergency start - Input
Device parameters → Motor control → Control stations → Mode selector S1
Further function blocks → Standard functions → Test / Reset → Reset 1 - Input
Not connected
Device parameters → Motor control → Control stations → PLC/PCS [DP] → ON <<
Not connected
Device parameters → Motor control → Control stations → PLC/PCS [DP] → ON <
Not connected
Not connected
Not connected
Not connected
Not connected
Not connected
Status - ON>>
Status - Off
Status - ON>
Event - Prewarning overload (I>115 %)
Status - Change-over pause active
Status - Remote mode
Status - General fault
Status - general warning
Status - ON<<
Not connected
Status - ON<
Status - Interlocking time active
Not connected
Not connected
Not connected
Not connected
Maximum current I_max
Not connected
Not connected
Not connected
Tables, data records
137