Fixing System - Canon iR C6800 Series Portable Manual

2.6 Fixing System

2.6.1 Points to Note When
Mounting the
Assembly
iR C6800C / iR C6800CN / iR 5800C / iR 5800CN
When fitting the fixing assembly into the fixing/
feeding assembly, take full care not to damage the 2
sensors [1].
[1]
F-2-72
2.6.2 After Replacing the
Fixing Roller
iR C6800C / iR C6800CN / iR 5800C / iR 5800CN
If you have replaced the fixing roller, be sure to
execute the following service mode item to reset the
counter reading:
COPIER>COUNTER>DRBL-1>FX-UP-RL
2.6.3 After Replacing the
Fixing Web
iR C6800C / iR C6800CN / iR 5800C / iR 5800CN
1. After attaching the web, take up its slack so that
there will be no slack when the web unit is fitted in the
Fixing
0004-1594
0004-5054
0004-1786
fixing assembly.
2. After replacing the web, reset the readings of the
following service mode items:
COPIER>COUNTER>MISC>FIX-WEB
COPIER>COUNTER>DRBL-1>FX-WEB
2.6.4 Position of the Fixing
inlet Guide
iR C6800C / iR C6800CN / iR 5800C / iR 5800CN
Do not loosen the screw on the inlet guide base
[1], as you would have to adjust the position of the
guide if you detached it. If you loosened it for some
reason, be sure to perform the following:
1) Adjust the position of the inlet guide base [1] so that
the height [A] at the center of the fixing inlet guide
[2] is 60.7 +/-0.2 mm and the difference in height
between the ribs [B] on both sides of the inlet guide
is 0.5 or less.
B
[2]
[1] [1]
F-2-73
F-2-74
Chapter 2
0004-2213
A B
[1]
A
2-41