Canon iR C6800 Series Portable Manual page 281

Subheadin
g
MF-
A4R,MF-
A6R,MF-
A4
<CLEANING>
Subheadin
g
TBLT-
CLN
WIRE-
CLN
T-5-49
COPIER>FUNCTION>CST
Contents
Use it to register the paper width basic value for the manual feeder.
A4R width: 210 mm; A6R width: 105 mm; A4 width: 297 mm
To make fine adjustments after registering the basic value, use the
following service mode item: COPIER>ADJUS'T>CST-ADJ>MF-
A4, RMF-A6R, MF-A4.
Method of Operation
1) Place A4R paper in the manual feeder, and adjust the side guide to
the A4R width.
2) Using this service mode, select 'MF-A4R' to highlight, and press the
OK key so that the value will be registered after auto adjustment.
3) Likewise, perform steps 1) and 2) above to register basic values for
A6R and A4.
T-5-50
COPIER>FUNCTION>CLEANING
Contents
Use it to clean the intermediate transfer belt.
By removing foreign matter (e.g., fingerprints, oils, paper lint) from
the intermediate transfer belt, a number of image faults may be
prevented.
Method of Operation
Select the item to highlight, and press the OK key to start the operation.
(The operation will stop automatically.)
Cleaning continues for about 80 sec, and will stop automatically.
Use it to cause cleaning of all charging wires at the same time 5 times
continuously.
Operation
1) Select the item, and press the OK key.
- The notation changes to 'ACTIVE', and the machine starts wire
cleaning.
2) Press the OK key once again to stop rotation.
Chapter 5
Level
1
Level
1
1
5-87