Registering The Paper Width Basic Value - Canon iR C6800 Series Portable Manual

Chapter 2
- If there still is a gap, go back to step 9).
11) Close the left deck.
2. Right Deck Left/Right Margin Adjustment
1) Push the release button, and slide out the right deck.
2) Open the upper right color and the lower right cover
3) Loosen the 2 screws [1]; then, insert a screwdriver
[2] through the opening in the front right stay, and turn
the adjusting screw to adjust the left/right margin.
[1]
[2]
F-2-103
4) Check to make sure that the left/right margin of
printouts made on paper from the right deck is as
indicated.
5) As necessary, perform the following:
[1]
[2]
F-2-104
- turn the screwdriver counterclockwise to decrease
the left margin [1].
- turn the screwdriver clockwise to increase the left
margin [1].
A full turn of the screwdriver changes the left margin
by 1.0 mm.
6) Tighten the 2 screws you loosened in step 3).
7) Close the upper right cover and the lower right
2-54
cover
8) Close the right deck.
- If the gap between the front cover/cassette 3 front
cover and the front right cover is appreciable, perform
the following:
9) Slide out the right deck, and loosen the 4 screws,
and shift the front right cover [2].
F-2-105
10) Close the right deck; when the gap is gone, slide
out the right deck once again, and tighten the 4 screws
you loosened in step 9).
If there still is a gap, go back to step 9).
11) Close the right deck.
2.8.4 Registering the Paper
Width Basic Value
iR C6800C / iR C6800CN / iR 5800C / iR 5800CN
1) Turn on the main power switch.
2) Register the A4R paper width basic value as
follows:
2-1) Set the manual feed side guide [1] to A4R.
[1] [1]
[1]
[2]
0003-9967