Canon iR C6800 Series Portable Manual page 292

Chapter 5
Subheadin
g
MN-CON
CARD
W-TN-
CLN
SND-
STUP
<MISC-R>
5-98
COPIER>FUNCTION>CLEAR
Contents
Use it to initialize the RAM on the main controller board SRAM
board.
- The contents of the RAM will not be initialized until the main power
switch has been turned off and then on.
- Executing this item will initialize all data on the SRAM board. In
other words, the file management information for the hard disk will
also be initialized, making reading of images from the hard disk
impossible. If you need to execute this mode, be sure that the user is
well aware of this fact.
Method of Operation
1) Print out the service mode settings using the following service mode
settings: COPIER>FUNCTION>MISC-P>P-PRINT.
2) Select the item, and press the OK key. In response, the machine will
automatically start up and prompt you to turn off and then on the main
power switch.
3) Turn off and then on the main power switch.
Use it to reset card ID-related data (group).
The card ID-related data will not be cleared until the main power
switch has been turned off and then on.
Method of Operation
1) Select the item, and press the OK.
2) Turn off and then on the main power switch.
Use it to reset a waste toner box full alert/error.
If you have replaced the waste toner box, execute this item to reset the
alert/error and initialize the counter used for the waste toner box
detection mechanism.
Use it to initialize the setting for the transmission reading. (Execute
this item when you switch language settings.)
Level
1
1
1
2