Canon iR C6800 Series Portable Manual page 311

Subheadi
ng
DM- Use it to enable/disable image density correction control as part of auto
MODE
gradation correction (PASCAL)
Settings
0: do not execute
1: execute
at time of shipment/upon RAM initialization: 0
SENS- Use it to set the original sensor.
CNF
Settings
0: AB configuration
1: inch configuration
at time of shipment/upon RAM initialization: 0
DM-SW Use it to enable/disable image gradation correction and image density
correction after making a specific number of prints.
Settings
0: do not execute (default)
1: execute every 200 prints up to initial 2000
2: execute every 200 prints up to initial 4000
3: execute at all times (every 200 prints)
4: reserved
To change the intervals (200 prints at default), use
COPIER>OPTIONAL>BODY>INTROT2.
at time of shipment/upon RAM initialization: 3
RAW- Use it to specify whether or not to print out received data as it is.
DATA If the received image has a fault, use this mode to find out whether the
fault is in the data or in the image processing.
Settings
0: normal operation
1: print as is
at time of shipment/upon RAM initialization: 0
BK-BND Use it to increase the black belt in 4C mode.
Use it to prevent photosensitive drum cleaning faults in an N/L
environment.
Settings
0: increase by 100%
1: increase by 150%
2: increase by 20%
at time of shipment/upon RAM initialization: 0
COPIER>OPTION>BODY
Contents Level
2
2
2
2
2