Canon iR C6800 Series Portable Manual page 362

Chapter 5
Subheadi
ng
PG-PICK
2-SIDE
PG-QTY
<NETWORK>
Subheadi
ng
PING
1) Turn off the main power switch.
2) Connect the network cable to the machine, and turn on the main power switch.
3) Inform the user's system administrator that the installation of the machine is over, asking him/her to make the
appropriate network settings.
4) Inform the user's system administrator that you will be checking the network connector, and find out the remote
host address (i.e., the IP address of the PC terminal on the user network) for use in the PING command.
5) Make the following selections in service mode: COPIER>TEST>NETWORK>PING. Then, enter the IP address
you obtained in step 4), and press the OK key and then the Start key.
5-168
COPIER>TEST>PG
Use it to select the source of paper for test printing.
Settings
1: cassette 1
2: cassette 2
3: cassette 3
4: cassette 4
5: side deck
6: manual feeder
7 to 8: not used
at time of shipment/upon RAM initialization: 1
Use it to set the output mode for test printing.
Settings
0: single-sided (at time of shipment/upon RAM initialization)
1: double-sided
at time of shipment/upon RAM initialization: 0
Use it to set the output mode for test printing.
Use it to set the copy count of test printing.
1 to 999
at time of shipment/upon RAM initialization: 1
T-5-83
COPIER>TEST>NETWORK
Contents
Use it to check the connection between the machine and the network
(for TCP/IP only).
Contents Level
1
1
1
Level
1