Canon iR C6800 Series Portable Manual page 305

Subheadi
ng
CONFIG Use it to select multiple pieces of firmware stored on the hard disk to
change the country, language, model, and paper size configuration.
Method of Adjustment
1) Select the item to change, and press the +/- key.
2) See that each press on the +/- key changes the particulars.
3) When all particulars are indicated for all items, press the OK key.
4) Turn off and then on the main power switch.
XXYYZZAA
xx: country (e.g., JP for Japan)
YY: language (e.g., ja for Japanese)
ZZ: model (e.g., 00 for Canon)
AA: paper size configuration (e.g., 00 for AB)
TEMP-
Use it to adjust the control temperature of the fixing assembly.
TBL
When this mode is activated,
- there will be an increase of 5 deg C in the following:
standby temperature (both types); copying temperature; post-standby
rotation temperature; extra-length sheet-to-sheet control temperature
- there will not be an increase of 5 deg C in the following:
post-job rotation temperature; power save mode temperature; error
detection temperature
Adjustments are made to the normally used temperature control table. A
change will be made to the fixing temperature control table in the event
of low-temperature offset or paper blister caused by the characteristics of
paper being used.
In the case of low-temperature offset, select +5 deg C; in the case of a
paper blister, on the other hand, select -5 deg C. The setting will not be
valid unit the main power switch has been turned off and then on again.
Settings
0: OFF
1: +5 deg C
2: -5 deg C
at time of shipment/upon RAM replacement: 0
COPIER>OPTION>BODY
Contents Level
1
1