Canon iR C6800 Series Portable Manual page 164

Cause
# 081
A password is not set in the remote
machine.
# 099
Sending was interrupted.
# 102
The subaddress and/or password do not
match.
# 107
The document could not be sent because
there was insufficient memory available.
# 701
The specified Department ID does not
exist, or the password has changed.
# 702
The document could not be sent because
the memory is full.
# 703
The memory for the image data is full.
# 704
An error occurred while reading address
information from the Address Book.
Remedy
Check the password of the remote
machine, and try again.
Try sending again.
Check the subaddress and/or password of
the remote machine, and try again.
1. Resend the document in a lower
resolution.
2. Erase unwanted documents to make
memory available.
3. If this problem occurs frequently,
contact your local authorized Canon
dealer.
Enter the correct Department ID or
password using 0-9 (numeric keys) on the
control panel, and try sending again.
1. Wait a few moments, and try again after
the other send jobs are complete.
2. Do not send the document to too many
recipients at the same time. Send the
document to a smaller number of
recipients each time.
1. Wait a few moments, and try again after
the other send jobs are complete.
2. Erase documents stored in inboxes. If
the machine still does not operate
normally, turn the main power OFF, and
then back ON again.
Check the address settings. If the machine
still does not operate normally, turn the
main power OFF, and then back ON again.