Canon iR C6800 Series Portable Manual page 147

Code Cause/Particulars of detection
0003 An error has been detected by a check
on the configuration when the external
controller is being started up.
0010 A controller for a non-Canon machine
is connected.
0080 There is an error in the communication
with the printer after the external
controller has started up normally.
E710 There is an error in IPC initialization.
0001 The machine fails to become ready
within 3 sec after the IPC chip has
started up.
E711 There is an IPC communication error.
0002 An error has been detected 4 times or
more within 1.5 sec after the
communication has been interrupted
between the finisher and the printer,
and the machine does not reset.
E713 There is a finisher communication error.
There is an error in the IC used for
communication by the sorter.
0001
E717 There is an error in the communication with the NE controller.
Remarks
Turn off the main power, and check the
cable; then, turn on the main power.
If the machine fails to start up, re-install
the system software of the external
controller.
Turn off the main power, and check to
see if the controller is an appropriate
type, and check the cable; then turn on
the main power.
If the machine fails to reset, re-install
the system software of the external
controller.
Turn off the main power, and check the
cable; then, turn on the main power.
If the machine fails to start up, re-install
the system software of the external
controller.
Turn off the main power, and check the
cable; then, turn on the main power.
Turn off the main power, and check the
cable; then, turn on the main power.
If the machine fails to reset, check the
connector between the finisher and the
copier for poor contact; as necessary,
replace the finisher controller/DC
controller.
Turn off the main power switch, and
check the wiring of the DC controller
PCB and the finisher controller PCB,
and check the 24V system fuse: then,
turn on the main power switch.
If the machine does not reset, replace
the DC controller PCB/finisher
controller PCB.