Subheadi
ng
TXPH
Use it to set image mode when generating test prints.
Settings
0: T-Mic (w/o end correction)
1: SC1 (w/o end correction)
2: SC2 (w/o end correction)
3: T-Mic (w/ end correction only if Bk)
4: SC2 (w/ end correction if Bk)
5: T-Mic (w/ gamma LUT auto correction)
6: SCI (w/ gamma LUT auto correction)
7: SC2 (w/gamma LUT auto correction)
8: T-Mic (w/ end correction if Bk; w/ gamma LUT auto correction)
9: SC2 (w/ end correction if Bk; w/ gamma LUT auto correction)
The setting herein is valid only for test prints.
at time of shipment/upon RAM initialization: 0
THRU
Use it to switch over image correction tables when generating test
prints.
Settings
0: on (use)
1: off (do not use)
at time of shipment/upon RAM initialization: 0
DENS-Y/
Use it to adjust the density of individual colors of a test print (TYPE=5).
M/C/K
settings range
0 to 255: a higher setting will make the image darker.
at time of shipment/upon RAM initialization: 128
COLOR-
Use it to set the output of individual colors for individual TYPEs.
Y/M/C/K
For example, to generate M in mono, set '1' to 'COLOR-M' and '0' to
others.
Settings
0: do not generate
1: generate
at time of shipment/upon RAM initialization: 1
F/M-SW
Set it to switch over full color and mono color during PG output.
Settings
0: full color output
1: mono color output
at time of shipment/upon RAM initialization: 0
COPIER>TEST>PG
Contents
Level
1
1
1
1
1