Error Code (Send) - Canon iR C6800 Series Portable Manual

3.2 Error Code (SEND)

3.2.1 Self-Diagnostic Display
iR C6800C / iR C6800CN / iR 5800C / iR 5800CN
Scanning has stopped because the size of the data for the scanned original exceeds the
limit. Scanning may be possible if [Data Cmprssn] is set to [High Ratio], Resolution is
lowered, or [Sharpness] is reduced.
Scanning was stopped because the data
size of the scanned original exceeded the
maximum data size that the machine could
handle.
Out of resources. Wait for a moment, then perform operation again.
You cannot browse the network. There is a
lack of TCP/IP resources because
documents have just been continuously
sent or are being continuously sent through
FTP or Windows (SMB).
Set the IP Address.
This machine is not set with an IP address.
No response from the server. Check the settings.
The specified server settings are incorrect,
or the server is not turned ON.
Alternatively, the machine's TCP/IP
resources may be low.
NetWare is in use. Wait for a moment, then perform operation again.
You cannot browse the network because
NetWare is printing through a Pserver or
NDS PServer.
There are too many subdirectories.
T-3-5
Cause Remedy
By selecting [High Ratio] for Data
Compression Ratio, lowering the
Resolution, and lowering the Sharpness
setting, scanning may become possible.
Wait for a while, and try browsing again.
Specify the IP Address Settings in TCP/IP
Settings in Network Settings in System
Settings (from the Additional Functions
screen), then turn the machine's main
power OFF and back ON again.
Wait for a while, and try browsing again. If
there is still no response from the server,
try selecting another server.
Wait until printing is complete, then try
browsing again.
Chapter 3
0005-6121
3-45