Canon iR C6800 Series Portable Manual page 140

Code Cause/Particulars of detection
0003 safety switch activation
E584 shutter unit error (Finisher-R1/R2)
8001 The shutter open sensor does not go off
(i.e., the shutter is not closed).
0002 The shutter open/closed sensor does not
go on (i.e., the shutter does not open).
E590 There is an error in the punch motor. (punch unit)
8001 The punching home position sensor is
not detected when the punch motor has
been driven for 200 msec.
8002 The puncher does not detect the
punching home position after the motor
has stopped (initial operation).
Remarks
1) Check the No. 2 tray sensors 1
through 3. Are the sensors normal?
2) Check the wiring between the finer
controller PCB and the No. 2 tray shift
motor. Is the wiring normal?
3) Is there a fault in the tray ascent/
descent mechanism?
4) Try replacing the No. 2 tray shift
motor. Is the problem corrected?
1) Check the shutter home position
sensor. Is the sensor normal?
2) Check the wiring between the
finisher controller PCB and the stack
edging motor and between the finisher
controller PCB and the shutter open/
close clutch. Is the wiring normal?
3) Is there a fault in the shutter
mechanism?
4) Try replacing the stack edging motor
or the shutter open/close clutch. Is the
problem corrected?
1) Check the shutter home position
sensor. Is the sensor normal?
2) Check the wiring between the
finisher controller PCB and the stack
edging motor and between the finisher
controller PCB and the shutter open/
close clutch. Is the wiring normal?
3) Is there a fault in the shutter
mechanism?
4) Try replacing the stack edging motor
or the shutter open/close clutch. Is the
problem corrected?
Check the punch home position sensor,
horizontal registration motor, and
punch driver PCB; then, turn off and
then on the main power.
Check the punch home position sensor,
horizontal registration motor, and
punch driver PCB; then, turn off and
then on the main power.