After Replacing The Primary Charging Wire - Canon iR C6800 Series Portable Manual

Chapter 2
- if Y
COPIER>FUNCTION>INSTALL>INISET-Y.
- if M
COPIER>FUNCTION>INSTALL>INISET-M.
- if C
COPIER>FUNCTION>INSTALL>INISET-C.
A countdown is shown on the screen while this
mode item is under way. At the end, the screen will
show "OK!".
This mode uses ATVC control, possibly taking a
while depending on the site environment. The count
on the screen, for this reason, may loop between 690
and 620.
19) Execute the following in service mode:
COPIER>FUNCTION>MISC-P>P-PRINT.
put the generated printout in the service book case. If
there is any previous printout, dispose of it.
20) End service mode, and select 'auto gradation
correction' in sure mode; execute auto gradation
correction (full correction) by going through the
instructions on the screen.
2.5.5 After Replacing the
Primary
Assembly
iR C6800C / iR C6800CN / iR 5800C / iR 5800CN
If you have replaced the primary charging assembly,
be sure to make the following adjustments:
1) Check the settings indicated on the primary
charging assembly height adjustment label attached
behind the front cover.
2) Make adjustments so that the charging wire height
of the new charging assembly is as indicated.
3) Execute primary charging assembly cleaning in
service
COPIER>FUNCTION>CLEANING>WIRE-CLN.
4) Make the following selections in service mode
(potential
COPIER>FUNCTION>DPC>DPC.
5) Turn off and then on the main power.
2-32
developing assembly,
developing assembly,
developing assembly,
Then,
Charging
0004-2166
mode:
control):
2.5.6 After Replacing the
Primary Charging Wire
iR C6800C / iR C6800CN / iR 5800C / iR 5800CN
1) Clean the charging wire, grid wire, and shielding
plates.
2) Execute the following in service mode (primary
charging
COPIER>FUNCTION>CLEANING>WIRE-CLN.
2.5.7 After Replacing the
Pre-Transfer
Wire
iR C6800C / iR C6800CN / iR 5800C / iR 5800CN
Execute the following in service mode (pre-transfer
charging
COPIER>FUNCTION>CLEANING>WIRE-CLN.
2.5.8 After Replacing the
Pre-Transfer
Wire
iR C6800C / iR C6800CN / iR 5800C / iR 5800CN
1) Clean the charging wire and the shielding plates.
2) Execute the following in service mode (pre-transfer
charging
COPIER>FUNCTION>CLEANING>WIRE-CLN.
2.5.9 After Replacing the
Waste Toner Box
iR C6800C / iR C6800CN / iR 5800C / iR 5800CN
1) Set the new waste toner box in the machine.
2) Execute the following service mode, thereby
resetting the waste toner counter reading to '0' (waste
0004-9315
wire cleaning):
Charging
0004-2672
wire cleaning):
Charging
0004-9316
wire cleaning):
0004-3914