Canon iR C6800 Series Portable Manual page 136

Code Cause/Particulars of detection
0002 The home position sensor does not go
on within a specific period of time after
the gear change motor has started to
rotate.
E530 There is an error in front alignment (finisher R1/R2).
8001 Th alignment motor has started to
rotate.e home position sensor does not
go off within a specific period of time
after the front
8002 The home position sensor does not go
on within a specific period of time after
the front alignment motor has started to
rotate.
E531 There is an error in stapling (finisher R1/R2).
0001 The home position sensor does not go
off within a specific period of time after
the stapler motor has started to rotate.
0002 The home position sensor does not go
on within a specific period of time after
the stapler motor has started to rotate.
E532 There is an error in the shift mechanism of the stapler. (finisher R1/R2)
Remarks
1) Check the gear change home
position sensor. Is the sensor normal?
2) Check the wiring between the fisher
controller PCB and the gear change
motor. Is the wiring normal?
3) Check the gear change mechanism.
Is there a fault?
4) Try replacing the gear change motor.
Is the problem corrected?
1) Check the pre-aligning plate home
position sensor. Is the sensor normal?
2) Check the wiring between the
finisher controller PCB and the pre-
aligning plate motor. Is the wiring
normal?
3) Check the path of the aligning plate.
Is there a mechanical obstacle?
4) Try replacing the pre-aligning plate
motor. Is the problem corrected?
1) Check the pre-aligning plate home
position sensor. Is the sensor normal?
2) Check the wiring between the
finisher controller PCB and the pre-
aligning plate motor. Is the wiring
normal?
3) Check the path of the aligning plate.
Is there a mechanical obstacle?
4) Try replacing the pre-aligning plate
motor. Is the problem corrected?
1) Check the wiring between the
finisher controller PCB and the stapler.
Is the wiring normal?
2) Try replacing the stapler. Is the
problem corrected?
1) Check the wiring between the
finisher controller PCB and the stapler.
Is the wiring normal?
2) Try replacing the stapler. Is the
problem corrected?