Canon iR C6800 Series Portable Manual page 149

Code Cause/Particulars of detection
100B At start-up, a mismatch occurs between
the version number indicated in the
master font management file of /
BOOTDEV and the bootable version.
There is no master font management
file in /BOOTDEV.
There is an error in the PDL master
font.
9004 There is an error in the PAI
communication with the external
controller.
There is an OPEN/IF communication
error.
9005 There is an error it the connection of the
video cable connected to the external
controller.
A006 PDL does not response, subootable is
out of order or does not exist.
There is a PDL communication error.
A007 At time of start-up, a mismatch occurs
between the version of the machine
control software and the version of the
PDL control software.
The PDL version is wrong.
B013 The font data is found to be damaged at
start-up.
PDL
E731 There is a UFR board error.
Remarks
Perform PDL resetting, or turn off and
then on the main power.
If the machine fails to reset, re-install
the font file or fully format and re-
install the system software.
Turn off the main power, and check the
open I/F board and the cable; then, turn
on the main power.
If the machine fails to reset, replace the
external controller, open I/F PCB, or
the main controller PCB.
Turn off the main power, and check the
open I/F board and the cable; then turn
on the main power.
If the machine fails to reset, replace the
eternal controller, open I/F PCB, or
main controller PCB.
Perform PDL resetting, or turn off the
main power, and check the connector of
the UFR board; then, turn on the main
power.
If the machine fails to reset, re-install
the firmware or replace the main
control PCB.
Perform PDL resetting, or turn off and
then on the main power.
If the machine fails to reset, fully
format and re-install the system
software.
There is an error in the built-in font. If
the error is not reset when the main
power has been turned off and then on,
perform full system formatting and
installation sessions.