Canon iR C6800 Series Portable Manual page 322

Subheadi
ng
SVMD- Switching the method of entering the Service Mode.
ENT
Setting Values
0: [User Mode key] -> Press [2] and [8] simultaneously -> [User Mode
key]
[Initial setting upon shipment/value after RAM clear]
1: [User Mode key] -> Press [4] and [9] simultaneously -> [User Mode
key]
Reference Information
Support for Siemens
DH- Patch Data (high density side) Used in D-half Except in Full Correction
MODE Change the default setting so that the readout collected from D-half at
time of full correction will be substituted for the patch on the high
density side at time of D-half (other than in full correction).
Settings
0: use patch image read data of full correction (at time of shipment/upon
RAM initialization)
1: do not use patch image read data of full correction
at time of shipment/upon RAM initialization: 0
W-CLN- Use it to set the intervals at which the primary charging wire/pre-transfer
PH charging wire is automatically cleaned.
If an image fault (e.g., vertical lines) occurs in a high temperature/
humidity environment, the intervals at which the primary charging wire/
pre-transfer charging wire is automatically cleaned may be changed.
Note: In a normal environment, be sure to use W-CLN-P to set the
intervals used to automatically clean the primary charging wire.
Range of settings
100 to 1000
at time of shipment/upon RAM initialization: 1000
B-SPL- Use it to set the environment table for black toner supply.
SW
settings range
0: variable
1: fixed
at time of shipment/upon RAM initialization: 0
B-CNT- Use it to set the environment table for black development contrast.
SW
settings range
0: variable
1: fixed
at time of shipment/upon RAM initialization: 0
COPIER>OPTION>BODY
Contents Level
2
2
2
2
2