Canon iR C6800 Series Portable Manual page 270

COPIER>ADJUST>FEED-ADJ
Subheadin
g
REGIST Use it to adjust the timing at which the registration roller clutch goes
on.
Method of Adjustment
- an increase of '1' will move the image in the direction of the leading
edge of the sheet by 0.1 mm.
- if you have initialized the RAM on the DC controller PCB or
replaced the DC controller PCB, enter the value indicated on the
service label.
Range of Adjustment: -50 to 50- (unit: 0.1 m)
at time of shipment: factory adjustment value/RAM initialization: 0
ADJ- Use it to adjust the horizontal adjustment for duplexing (for factory
REFE use).
Method of Adjustment
- an increase of '1' will move the image on the 2nd side to move toward
the rear by 0.1 mm.
Range of Adjustment: -100 to 100
at time of shipment: factory adjustment value
upon RAM initialization: 0
BLK-SML2 Use it to adjust the left/right margin on the 2nd side for small size.
- an increase of '1' will make the left-right margin on the 2nd side
longer by 0.1 mm.
Range of Adjustment: -50 to +50 (unit: 0.1 mm)
at time of shipment: factory adjustment value
upon RAM initialization: -15
RVS-FD1 Use it to adjust the print of reversal.
Range of Adjustment: -10 to +10 (unit: 1 mm)
at time of shipment: factory adjustment value
upon RAM initialization: 0
RVS-DUP Use it to adjust the point of duplexing reversal.
Range of Adjustment: -10 to 10
at time of shipment: factory adjustment value
upon RAM initialization: 0
T-5-39
Contents Level
1
1
1
2
2