Configuring A Remote Source Group On The Source Device - HPE FlexFabric 5700 Series Network Management And Monitoring Configuration Manual

Step
1. Enter system view.
2. Configure the remote probe
VLAN for the specified
remote destination group.
Assigning the monitor port to the remote probe VLAN
Step
1. Enter system view.
2. Enter the interface view of
the monitor port.
3. Assign the port to the
remote probe VLAN.

Configuring a remote source group on the source device

Creating a remote source group
Step
1. Enter system view.
2. Create a remote source
group.
Configuring source ports for a remote source group
To configure source ports for a mirroring group, use one of the following methods:
•
Assign a list of source ports to the mirroring group in system view.
•
Assign a port to the mirroring group as a source port in interface view.
To assign multiple ports to the remote source group as source ports in interface view, repeat the
operation.
When you configure source ports for a remote source group, follow these restrictions and guidelines:
•
Do not assign a source port of a remote source group to the remote probe VLAN of the remote
source group.
•
A mirroring group can contain multiple source ports.
•
A port can act as a source port for multiple mirroring groups.
•
A source port cannot be used as a reflector port, monitor port, or egress port.
•
When you configure a TRILL access port as a source port, only non-TRILL-encapsulated
packets can be mirrored. Other packets are dropped.
•
When you configure a TRILL trunk port as a source port, only TRILL-encapsulated packets can
be mirrored. Other packets are dropped.
Command
system-view
mirroring-group group-id
remote-probe vlan vlan-id
Command
system-view
interface interface-type
interface-number
•
For an access port:
port access vlan vlan-id
•
For a trunk port:
port trunk permit vlan vlan-id
•
For a hybrid port:
port hybrid vlan vlan-id { tagged |
untagged }
Command
system-view
mirroring-group group-id
remote-source
172
Remarks
N/A
By default, no remote probe VLAN
is configured for a remote
destination group.
Remarks
N/A
N/A
For more information about the
port access vlan, port trunk
permit vlan, and port hybrid
vlan commands, see Layer
2—LAN Switching Command
Reference.
Remarks
N/A
By default, no remote source
group exists on a device.