Vxlan Configuration Examples; Unicast-Mode Vxlan Configuration Example - HPE FlexFabric 5940 Series Configuration Manual

Task
interfaces.
Display VXLAN tunnel information for
VXLANs.
Display the VXLAN hardware resource
allocation mode.
Clear ARP flood suppression entries
on VSIs.
Clear dynamic MAC address entries on
VSIs.
Clear packet statistics on VSIs.
Clear packet statistics on ACs.
NOTE:
For more information about the display interface tunnel command, see tunneling commands in
Layer 3—IP Services Command Reference.

VXLAN configuration examples

Unicast-mode VXLAN configuration example

Network requirements
As shown in
•
Configure VXLAN 10 as a unicast-mode VXLAN on Switch A, Switch B, and Switch C to provide
Layer 2 connectivity for the VMs across the network sites.
•
Manually establish VXLAN tunnels and assign the tunnels to VXLAN 10.
•
Enable remote-MAC address learning.
Figure 9 Network diagram
VM 1
VLAN 2
Server 1
Configuration procedure
1. Configure IP addresses and unicast routing settings:
Figure 9:
Loop0
1.1.1.1/32
Vlan-int11
XGE1/0/1
11.1.1.1/24
Switch A
Loop0
2.2.2.2/32
Command
down ] ]
display vxlan tunnel [ vxlan vxlan-id ]
display hardware-resource [ vxlan ]
reset arp suppression vsi [ name vsi-name ]
reset l2vpn mac-address [ vsi vsi-name ]
reset l2vpn statistics vsi [ name vsi-name ]
reset l2vpn statistics ac [ interface interface-type
interface-number service-instance instance-id ]
Transport network
Vlan-int11 Vlan-int13
11.1.1.4/24 13.1.1.4/24
Vlan-int12
Switch D
12.1.1.4/24
Vlan-int12
12.1.1.2/24
Switch B
XGE1/0/1
VLAN 2
VM 2
Server 2
21
Loop0
3.3.3.3/32
Vlan-int13
XGE1/0/1
13.1.1.3/24
VLAN 2
Switch C
VM 3
Server 3