Path Jitter Operation Configuration Example - HPE FlexFabric 5700 Series Network Management And Monitoring Configuration Manual

[DeviceA-nqa-admin-test1-dlsw] history-record enable
[DeviceA-nqa-admin-test1-dlsw] quit
# Start the DLSw operation.
[DeviceA] nqa schedule admin test1 start-time now lifetime forever
# After the DLSw operation runs for a period of time, stop the operation.
[DeviceA] undo nqa schedule admin test1
# Display the most recent result of the DLSw operation.
[DeviceA] display nqa result admin test1
NQA entry (admin admin, tag test1) test results:
Send operation times: 1
Min/Max/Average round trip time: 19/19/19
Square-Sum of round trip time: 361
Last succeeded probe time: 2011-11-22 10:40:27.7
Extended results:
Packet loss ratio: 0%
Failures due to timeout: 0
Failures due to disconnect: 0
Failures due to no connection: 0
Failures due to internal error: 0
Failures due to other errors: 0
# Display the history records of the DLSw operation.
[DeviceA] display nqa history admin test1
NQA entry (admin admin, tag test1) history records:
Index
1
The output shows that the response time of the DLSw device is 19 milliseconds.

Path jitter operation configuration example

Network requirements
As shown in
Device A to Device B and Device C.
Figure 50 Network diagram
Configuration procedure
# Assign each interface an IP address. (Details not shown.)
# Configure static routes or a routing protocol to make sure the devices can reach each other.
(Details not shown.)
# Use the ip ttl-expires enable command on Device B and use the ip unreachables enable
command on Device C.
# Create a path jitter operation.
<DeviceA> system-view
Response Status
19 Succeeded
Figure 50, configure a path jitter operation to test the round trip time and jitters from
Receive response times: 1
Time
2011-11-22 10:40:27.7
154