Source Interface (Icmp Echo/Udp Tracert Operation View) - HPE FlexNetwork 10500 Series Network Management And Monitoring Command Reference

Syntax
route-option bypass-route
undo route-option bypass-route
Default
The routing table bypass feature is disabled.
Views
ICMP echo/TCP/UDP echo operation view
DLSw/DNS/FTP/HTTP/SNMP operation view
UDP tracert operation view
ICMP jitter/UDP jitter/voice operation view
Predefined user roles
network-admin
mdc-admin
Usage guidelines
When the routing table bypass feature is enabled, the following events occur:
•
The routing table is not searched. Packets are sent to the destination in a directly connected
network.
•
The TTL value in the probe packet is set to 1. The TTL set in the ttl command does not take
effect.
Examples
# Enable the routing table bypass feature.
<Sysname> system-view
[Sysname] nqa entry admin test
[Sysname-nqa-admin-test] type icmp-echo
[Sysname-nqa-admin-test-icmp-echo] route-option bypass-route

source interface (ICMP echo/UDP tracert operation view)

Use source interface to specify the IP address of an interface as the source IP address of probe
packets.
Use undo source interface to restore the default.
Syntax
source interface interface-type interface-number
undo source interface
Default
The probe packets take the primary IP address of the outgoing interface as their source IP address.
Views
ICMP echo operation view
UDP tracert operation view
ICMP template view
78